Product Description
Michigan Motorsports LS Billet Aluminum Oil Diverter Barbell & Oil Bypass Delete Kit
Fits Gen III & IV LS Engines | 4.8L, 5.3L, 5.7L, 6.0L, 6.2L & 7.0L
Address two paths for unfiltered oil with this LS oil diverter barbell and bypass delete kit. The 7075 billet aluminum barbell replaces the factory plastic component with a tighter-fitting design and a smaller shaft for reduced flow restriction. The aluminum bypass plug replaces the check valve in compatible oil filter adapter housings, closing that bypass route. A replaceable high-temperature Viton O-ring and threaded removal holes add serviceability to the assembly.
Key Features & Benefits
- Precision-Fit 7075 Billet Barbell: The oil diverter barbell uses 7075 billet aluminum in place of the factory plastic design. Its stated clearance is approximately .001 inch versus approximately .020 inch for the factory component, reducing the clearance through which oil and debris can bypass.
- 30 Percent Smaller Barbell Shaft: Oil must travel around the barbell shaft to reach the oil port. The reduced shaft size leaves more room for that flow, decreasing restriction at this passage without representing the change as a guaranteed percentage increase in oil flow.
- Filter Adapter Bypass Plug: The aluminum plug replaces the factory check valve in the compatible filter adapter housing. It blocks that valve’s bypass path, preventing unfiltered oil from entering through this specific route when the original check valve would otherwise open.
- Replaceable Viton O-Ring: Features a high-temperature Viton O-ring that can be replaced during service. The serviceable seal complements the billet barbell’s tighter-fitting design without requiring replacement of the entire component when the O-ring needs attention.
- Threaded Holes For Removal: Both the barbell and bypass plug feature a 1/4-20 threaded hole in the end. Thread a compatible bolt into the component to provide a pulling point if removal becomes necessary.
Notes
- Filter Adapter Housing Required: The bypass plug requires a check valve located in the oil filter adapter housing, as shown in the product photos.
- Oil Pan Bypass Exclusion: The bypass plug will not work with applications where the bypass valve is located inside the oil pan.
- Bypass Function Changes: The factory check valve provides a safety path if the oil filter becomes restricted. Installing this plug removes that housing-level bypass path; it does not eliminate a separate bypass built into the oil filter itself.
Key Fitments
Fits GM Gen III & IV LS Engines — Bypass Plug Compatibility Depends on Valve Location:
- Engine displacements: 4.8L, 5.3L, 5.7L, 6.0L, 6.2L and 7.0L
- Engine applications include LS1, LS2, LS3, L92, LQ4 and LQ9
- Oil diverter barbell: GM Gen III & IV LS engines
- Oil bypass plug: applications with the bypass check valve in the oil filter adapter housing, not inside the oil pan
Product Videos
Custom Field
Product Reviews
1 Review Hide Reviews Show Reviews
-
Quality parts
I just installed the barbell and it gives me comfort compared to the plastic part that looked fragile and discolored.